Remove Configuration File from Fabric IPsec Gateway VM

About this task

Perform this procedure to remove a specific configuration file from Fabric IPsec Gateway Virtual Machine (VM).

Procedure

  1. Enter Fabric IPsec Gateway Configuration mode:

    enable

    virtual-service WORD<1-128> console

    Note

    Note

    Type CTRL+Y to exit the console.

  2. Remove the configuration file:

    remove WORD <1-255>

Example

Remove configuration file "test" from Fabric IPsec Gateway VM:
Switch:1> enable
Switch:1# virtual-service figw console
Connected to domain figw
Escape character is ^Y

  <cr>
FIGW> remove test

Variable Definitions

The following table defines parameters for the remove command.

Variable Value
WORD <1-255> Specifies the configuration file name that the system removes from Fabric IPsec Gateway VM.
9039040-00 Rev AB